Boxes, yet more boxes, and bowls

Another 10 days of silversmithing spread over 10 weeks and I now have a collection of 7 boxes in various stages of completion and in various alloys; gilding metal (3 boxes), nickel silver, sterling silver, silicon bronze and phosphor bronze. And another two gilding metal bowls and a silicon bronze mirror (see next post). Below left is the silicon bronze box, the pin has been left untrimmed for ease of removal of the lid. I have inserted a complete inner box, primarily to hide the solder seams which were more unsightly than usual and almost impossible to clean up (although they can be plated). I have not as yet fitted any kind of catch (that's something I still have to learn about!). The colour after sanding etc is actually a bright golden yellow, not the red-brown in the photo that is typical of an acid-pickled appearance and is due to copper enrichment of the surface. The acid (dilute sulphuric) dissolves the black copper oxide formed during all heating operations, but doesn't dissolve the copper (which from this point of view is regarded as a noble metal). It also seems to dissolve in some way some of the alloy ingredient (in this case silicon, in the case of the gilding metal boxes it is zinc) leaving the copper-rich surface behind. This is generally called depletion gilding, although it would better be called depletion coppering in these cases! The picture to the right is a rear view to show the flush hinge, with the knuckles filed down flush with the side wall; this required that the hinge groove be very carefully placed, too deep and the lid wouldn't open far, too shallow and filing the knuckles flush would expose the hinge pin.
Pictures of all boxes and artwork generally can be seen at http://www.flickr.com/photos/jelf0/ All the boxes except the last (the phosphor bronze, which is a 'standard' or 'traditional' bronze in the sense that it is primarily a 92% copper, 8% tin alloy) are complete with lids, hinges and pins but without the customisation I hope to use later. The phosphor bronze box at present has neither lid nor base, and therefore no hinge or pin. The sheet I bought (from Columbia Metals Ltd) was 4'x2', 16swg (nominally 1.63mm thick), and therefore much too thick to use for ordinary silversmithing for bashing into bowls etc; and forging it to decrease the gauge has proved very arduous and time-consuming. So it looks destined to turn into lots of boxes!